background image

CAUTION 1:

TURN ALL POWER OFF. NEVER EXPOSE EYES OR SKIN TO UVC LIGHT FROM ANY SOURCE - WEAR GLOVES,

FACE SHIELD AND COVER ALL EXPOSED SKIN. DO NOT TOUCH EMITTER

TM

GLASS WITHOUT GLOVES.

CAUTION 2:

INSTALL EMITTER TUBE BEFORE APPLYING POWER. FAILURE TO DO SO WILL TRIGGER THE "END-OF-LAMP-

LIFE CIRCUIT" AND THE EMITTER WILL FAIL TO LIGHT! IF THIS HAPPENS SHUT OFF POWER FOR 10 SECONDS, REINSTALL /
INSTALL EMITTER AND TURN POWER BACK ON. EMITTER WILL LIGHT.

NOTE: Read this entire instruction sheet before starting the installation.

Made in USA

p

WARNING

!

Before installing fixture or performing maintenance or service on
fixture, turn off main power switch to unit. Electrical shock can cause
injury or death. There may be more than one disconnect switch.

p

CAUTION

!

Never expose eyes or skin to ultraviolet light from any source. After
installation, provide an interlock to turn off germicidal lamps when
access door is opened. Lamp must be off before entering HVAC unit
to perform maintenance or service. Personal injury may result.

p

CAUTION

!

Do not touch lamp glass without gloves. Damage to Emitter™ may
result. Oil from fingerprints will permanently etch glass of lamp and
weaken structure. Clean lamp after handling.

p

CAUTION

!

Use only specified high-output, low temperature lamp with this
fixture. Use of a lower wattage or incorrect lamp can result in
damage to accessory or Emitter.

Safety Considerations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.0
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2.0
Installation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3.0
Operation & Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4.0
Trouble Shooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5.0
Illustrations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6.0
Spare or Replacement Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7.0

1.0   SAFETY CONSIDERATIONS

TABLE OF CONTENTS

MODEL

SE SERIES

120-277 Vac.

Patents 5,334,347; 5,817,276; 5,866,076; 6,245,293; 6,267,924;

6,280,686; 6,313,470; 6,372,186; 6,423,882; 6,500,267; 6,589,476; 6,627,000

INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS

Improper installation, adjustment, alteration, service,
maintenance, or use can cause fire, electrical shock, or
other conditions which may cause personal injury or
property damage.

Consult a qualified installer, service

agency, or your supplier for information or assistance.

The qualified installer or agency must use factory kits or
accessories when installing this product.

Refer to the

individual instructions packaged with kits or accessories
when installing them.

Follow all safety codes, wear safety glasses and work
gloves. Read all instructions thoroughly and follow any
warnings or cautions attached to any accessed area.
Consult local building codes and the National Electrical
Code (NEC) for special requirements.

Understand the signal words 

DANGER, WARNING

or

CAUTION.

These words are universally used for overall 

safety.

DANGER

identifies the most serious hazards,

which will result in severe personal injury or death.

WARNING

signifies hazards, which could result in

personal injury or death.

CAUTION

is used to identify

unsafe practices, which would result in minor personal
injury or product and property damage.

p

CAUTION

!

Lamp contains a small quantity of mercury. If an lamp breaks, clean
and dispose of with care.

Содержание SE Series

Страница 1: ... General 2 0 Installation 3 0 Operation Maintenance 4 0 Trouble Shooting 5 0 Illustrations 6 0 Spare or Replacement Parts 7 0 1 0 SAFETY CONSIDERATIONS TABLE OF CONTENTS MODEL SE SERIES 120 277 Vac Patents 5 334 347 5 817 276 5 866 076 6 245 293 6 267 924 6 280 686 6 313 470 6 372 186 6 423 882 6 500 267 6 589 476 6 627 000 INSTALLATION OPERATION AND MAINTENANCE INSTRUCTIONS Improper installation ...

Страница 2: ... Wrap suspect items with aluminum tape use metallic conduit or use other appropriate shielding where these items may be in line of sight of UVC 3 4 Determine the most desirable location for the intended use and install reflecting material CAUTION Do not drill into coil Freon lines or other mechanical equipment 3 5 Using the fixture base as a template scribe and then create one insertion hole 1 dia...

Страница 3: ...wiring to Emitter 7 Replace power supply 5 2 Low Output Radiometer Reading or Visibly Weak Light 1 Replace Emitter with known working Emitter 2 Check line voltage 3 Check wiring to Emitter 5 3 Red Orange Light 1 Check ambient temperature If the temperature is at or below 35 F Emitter is too cold to operate properly 2 If ambient temperature is in excess of 35 F follow actions for the Low Output sym...

Страница 4: ...he 1 UVC for HVAC product sold worldwide Please contact your local supplier or Steril Aire directly if we can provide any further information or service Your satisfaction is very important to us Please call 1 800 2 STERIL 783745 or log onto www steril aire com Steril Aire Inc cannot and does not guarantee that all organisms will be inactivated or killed or that use of Steril Aire Inc UVC Emitters ...

Отзывы: