4
Step 6:
Prepare the included 6” length of flat ribbon cable to connect the driver board and the
remote board. This cable will have a 2x4 IDC socket on one end, and the other end will need to
have the wires 1, 2, 6, 7, and 8 separated, stripped, and tinned to prepare for soldering.
Note: The
ribbon cable has a red wire on one side. That red wire is wire #1, the one next to it is #2, and so on.
Fig. 3
Ribbon cable
Step 7:
Locate the area shown inside the red box in Figure 4.
Fig. 4
Driver Board Pad Locations
