2112 116TH AVE NE SUITE 1-5, BELLEVUE WA, 98004 WWW.STEPPIR.COM TEL: (425)-453-1910 FAX: (425)-462-4415
3
CONTROL BUTTONS
POWER
During power up all 7 LED lights will light and the display will show what antenna software the
controller is programmed with along with the program version,
After 3 seconds the display will change to the last used function and operating frequency.
From the factory the screen will appear as shown below.
The power light will remain lit along with the
NORM
light or depending on the last mode you
were operating on. example:
180
or
BI (3/4)
and also
AUTOTRACK
if you are using a
Transceiver Interface.
NOTE:
Even if your controller is turned off by using the
POWER
button there is still a holding current
being sent out to the elements on the antenna. This is to hold the antenna element in the
exact position after being used.
FREQUENCY ADJUST
This function gives the user the ability to adjust his/her antenna with great accuracy and
speed. Giving the user the range to move between 59.990Mhz to 6.950Mhz and tunning the
antenna every 50Khz. This is achieved by using three different control buttons,
BAND,
COARSE
and
FINE
.
BAND UP / DOWN
This will move the antenna to whatever band the user selects. The factory defaults are as
shown in
Figure 1.
Whenever the controller is tuning the antenna the tunning light will be
blinking red.
These two up and down buttons also have a duel perpuse by acting as a toggle up and
down for the SET UP function. This will be described in greater detail later in the the manual.
COARSE UP / DOWN
Adjusts the frequency by 100Khz either up or down.
FINE UP / DOWN
Adjusts the frequency by 10Khz either up or down.
Manual Mode
Elements Home