11
Reconnecting Feed Rate to Motor
1.
Before reconnecting the feed rate control to the motor,
confirm pressure spring is in place and place feed rate
control on the shaft.
2.
Turn the feed rate control counterclockwise to line up the
flat side of the motor shaft (d shaft) with the flat side of
the spider (in the feed rate control) and push straight on.
3.
Push and turn the feed rate control until the rivets (on the
gear case) are inside the rivet holes on the feed rate.
4.
Turn counterclockwise until it locks into place and the
“bump” on the feed rate mounting plate fits into the
indentation in the gear case cover.
NOTE
Additional information
The arrow on the feed rate control should be on
top and confirm the bump is in the indentation.
