W W W . S T E L L A D O R A D U S . C O M
W W W . S T E L L A D O R A D U S . C O M
i
REPEATER
i
REPEATER
1
1
Contents of the kit
Dimensional Drawing(mm)
Snap QR code to visit
Installer Zone for more
installer resources.
This manual is for the following models
Blue box - band is active
The LCD allows users to easily read the repeater diagnostics, control the gain of each band, turn on/off any band, and
easily allows for general configuration.
*The iR4 has only 2 ports for 2 internal antennas.
dB Page
Main Page
LCD - 5” full colour touch
Quick installation and user manual
Long press to reboot:This is similiar to plugging out and in mains power.
Short press to reset: This just rebalances the levels.
Band is Active.
Frequency
No issues
Band is self optimizing.
Strong outdoor signal. No action required as the repeater will self optimize.
Indoor and outdoor antennas are too close to each other. Separate them more.
External signal is too strong and band has shut down. Add manual attenuation.
Band has automaticlly turned off due to very high downlink (DL) power.
Internet status
2-After using group attenuators, use these individaul attenuators to do fine adjustments per band.
Uplink (UL) power received by the amplifier. (Power emitted by the phone)
DL power from the operator, received by the amplifier.
UL Automatic Gain Control (AGC) - starts when UL power limit is reached
AGC for UL and DL when the operator’s signal is strong.
When outdoor signal is very strong, gain is reduced for an extended time.
Add extra attenuation to high or low bands.
Add attenuation to any band individually.
Sum of total AGC on the DL. This value can be used in FloorPlanner tool.
Yellow box - strong uplink from phone.
Outdooor
antenna
*Outdoor 15m
cable SD400
*Indoor
antennas x 4
Indoor cables
4x SD400
*Custom cable lengths supplied
iRepeater
PIN Access
A secret PIN can lock out access to the LCD display. The PIN is set on the clients account on the platform. Default
PIN 888888,
Internal location
Enter a note about the amplifier. This note is sent and displayed on the stellacontrol inventory page. E.g. Internal
location of the amplifier.
Other LCD features
Toggle Band Page
Model
Bands
Ports
PSU
Weight
Dims cm
iR4-LGDW*
B20,B8,B3,B1
2
12V,5A
1.6kg
27X29X3.8
iR5-EU
B20, B8, B3, B1, B7
4
12V,5A
2.8kg
43X30X3.8
iR6-EU
B28, B20, B8, B3, B1, B7
4
12V,5A
2.8kg
43X30X4.8
iR5-US
B28, B4, B5, B25, B7
4
12V,5A
2.8kg
43X30X4.8
1-Use high and low group attenuator to control either the low bands 700/800/900
and/or the high bands, 1800/2100/2600.
Use these group attenuators to first control very strong signal. Then, make fine
adjustments with the individual attenuators.
Switch On/Off band
