Stel 601267000L, Инструкция по эксплуатации

Страница: 14 / 38

6943100020
14
LIFTING
WARNING :
The machine weights without rolls…
TOP 504 XXM
19 Kg / 41,88 lb
Lifting by hand:
It is possible lifting the machine by hand without
spool.
ATTENTION! No lifting the machine with 15 Kg
spool by himself .
Before lifting the machine take out the 15 Kg spool.
FRONT PANEL DESCRIPTION
1
ELECTRODE led indicating mode
2 MIG 2T led indicating mode
3 MIG 4T led indicating mode
4 SPOT WELDING led indicating mode
5
MULTI SPOT WELDING led indicating mode
6 SELECT MODE button
7 Function Selection button
8 Function Selection button
9 Function Selection button
10 Function Selection button
11
Encoder for Voltage regulation/other Functions
V/SET ;
12
Encoder for Wire Speed / Amps regulation A/
W.Sp
PREPARING FOR
ELECTRODE WELDING
a Welding current;
b Signal of pulsation enabled;
c Access to JOB LIST menu;
d Access to
DC PULSE
menu
e Access to SETUP menu.
Preparation of the machine
a) Connect the earth cable to the negative socket
of the generator;
b) Connect the interconnecting cables on the front
of the generator, the power cable on the positive
socket and the circular 14-way connector on the
socket.
c) Connect the wiring harness to the wire feed unit,
inserting the power cable to the rear Din socket
(item I), and the connector into the socket (ref. G);
d) Connect the electrode holder to the front Din
socket of the wire feeder marked with the electrode
symbol (ref. B)
e) Insert the uncovered electrode core into the
electrode holder;
f) Insert the generator power plug into a suitable
power outlet
g) Turn on the generator.
Adjustment of welding parameters in electrode
mode
1) Press the SELECT MODE mode selection
button (ref.6) until the ELECTRODE mode LED
lights up (ref.1)
2) Set the welding current with the A / Vel control
encoder. (ref.12);
3) Proceed with welding.
4) Press the SETUP button (ref.10) to enter the
ELECTRODES
ARC SETTINGS adjustment
screen. To set the Hot Start value, adjust the V /
SET encoder (ref.11). The value of Hot Start is
adjustable from 0 to 50% of the set welding current
value. To set the Arc Force value, press the
SELECT button (ref.8) and adjust with the V / SET
encoder (ref.11).
PULSE DC, attivation and regulation.
To activate the Pulse function, press the ref button
9 to enter the PULSE PARAMETERS screen and
then press the ref button 9 again to activate it.