Steinberg UR28M, Руководство по эксплуатации

Страница: 16 / 40

Panel Controls for the Software Programs
UR28M
Operation Manual 16
Setup Window
This is the window for configuring the common
settings of the device.
1 CONTROL PANEL
For Windows, this opens the “Control Panel of the
Audio Driver” (page 10). For Mac, this opens the
Audio MIDI Setup.
2 INPUT 3/4 LEVEL
Selects the input signal level of LINE INPUT 3/4.
Option: +4dBu, -10dBV
3
HPF
Selects the cutoff frequency of the high pass filter.
Option: 120 Hz, 100 Hz, 80 Hz, 60 Hz, 40 Hz
4 INPUT METER SETTING
Selects the analog input jacks whose input signal
levels are indicated on the INPUT meter on the
device.
5 S/PDIF OUT
Selects the output signal of the S/PDIF OUT.
6
OUTPUT (A/B/C) MODE SELECT
Selects the function (mode) of the LINE OUTPUT
A–C.
There are two modes, Alternate and Independent.
7
Master Source
Indicates the LINE OUTPUT.
8
Master Level
Indicates the output signal level of the LINE
OUTPUT.
9 LINK (Independent mode only)
Lets you enable (checkmark) or disable (no
checkmark) the function which adjusts the level of
all LINE OUTPUT signals by the OUTPUT LEVEL
knob on the device at the same time.
For instructions on how to adjust the output signal
level with LINK disabled, refer to the “OUTPUT
LEVEL knob” (page 9) in the section “Panel
Controls and Terminals (Details).”
)
KNOB MOUSE CONTROL
Selects the method of operating the knobs on the
dspMixFx UR28M.
Option Description
INPUT 1-2 Indicates the input signals of MIC/
LINE/HI-Z 1/2.
INPUT 3-4 Indicates the input signals of LINE
INPUT 3/4.
Mode Description
Alternate One of the LINE OUTPUTS A–C
selected by the OUTPUT buttons
A–C outputs a single MIX signal
selected by the SOURCE SELECT
button.
Independent The LINE OUTPUTS A–C output
each MIX selected by the SOURCE
SELECT button at the same time.
Option Description
Circular Drag in a circular motion to increase
and decrease the parameter. Drag in
a dial clockwise to increase, and
counterclockwise to decrease. If you
click any point on the knob, the
parameter will jump there instantly.
Linear Drag in a linear motion to increase
and decrease the parameter. Drag to
the upward or rightward to increase,
and downward or leftward to
decrease. Even if you click any point
on the knob, the parameter will not
jump there.