Steinberg Nuendo Time Base, Руководство по эксплуатации, Страница: 45 / 92

TIME BASE
Reference 5 – 45
This shows and lets you select a Time Code Generator status.
Parameter Explanation
TX=
Transmit – The transmitted Playspeed Time Code value is shown.
TXo+= The transmitted Playspeed Time Code value as modified by the Offset is
shown. This function is not available during Generator operation.
Parameter Explanation
WAIT: Waiting for Time Code Input. During JAM-SYNC this is where the Generator
is started from.
RUN: Incoming Time Code will be regenerated.
The following functions are only available in Generator Mode:
STOP:
Generator is stopped.
START: Generator is running.
RESET: By pressing the Left or Right button on the Time Base, the Generator is re-
set to zero.
EDIT: This function makes it possible to set any Start position by changing the
numbers in the TX field.
PRESET: By changing the numbers in the TX field a Start position (Preset) can be set,
which is retained when you leave the PRESET field. Very often tapes are
“striped” with a Time Code Start of 09:58:00:00 (with a picture start of
10:00:00:00). The Generator Start position thus only needs to be input once.
STARTP: Start Preset. Pressing the Left or Right button causes the Generator to
start from the Preset position.
FRM=25 TCIN=OFF GENERATOR SR=96.00
CL:INTERNAL
TX=10:00:00:00 STOP P.1
FRM=25 TCIN=OFF GENERATOR SR=96.00
CL:INTERNAL TX=10:00:00:00
STOP P.1