Steinberg AXR4T, Начало работы

Страница: 11 / 20

Supplying Power
AXR4 Getting Started 11
Supplying Power
Connecting the Power Adaptor
1.
Make sure that the [ P /I] switch on the
front panel of the AXR4 device is in the
[
P ] position (the power is off).
2.
Connect the power code to the power
adaptor.
3.
Insert the plug of the power adaptor into
the DC IN [24V] jack on the rear panel of
the AXR4 device.
4.
Insert the plug of the power cord into an
outlet.
Turning the Power On and Standby
Power On
To turn the power on, push the [ P /I] switch on the front
panel of the AXR4 device to the [I] position.
The opening screen appears on the front panel display.
Power Standby
To set to Standby, push the [ P /I] switch on the front panel
of the AXR4 device to the [ P ] position.
The front panel display turns off.
NOTE
• Even when the [
P
/I] switch is in the standby position,
electricity is still flowing to the unit. If you do not plan to use the
unit for a while, be sure to unplug the power cord from the
outlet.
• Make sure there is adequate distance between the power
adaptor and the device.
WARNING
• Only use the included AC adaptor and power
cord (or an equivalent recommended by
Yamaha). Using the wrong adaptor or power
cord can result in damage to the device,
overheating or fire.
• Remove the power cord from the outlet when
the device is not be used for extended
periods of time, or during electrical storms.
Failure to do so may result in electric shock,
fire, or damage to the device.
2
3
4
Power adaptor
WARNING
Before turning the power switch on or
standby, set all volume levels to minimum.
Failure to do so may damage your hearing,
result in electric shock, or damage the
equipment.
NOTICE
Setting the [
P
/I] switch to on and standby in rapid
succession can cause it to malfunction. After setting the
[
P
/I] switch to standby, wait for about six seconds before
setting it to on again.