Steinbach Solardusche Split, Оригинальное руководство пользователя, Страница: 32 / 275

3. Route the garden hose to the shower location.
Make sure that the hose is not pulled taut, does not pose a trip hazard, and cannot
be damaged by a lawnmower or similar devices.
4. Mark the drilling points for the wall
anchors through the holes in the base
of the shower.
5. Remove the shower from the base.
6. Use a drill to drill the holes in the base.
7. Use a rubber mallet to drive the wall
anchors from the supplied fastening kit
into the holes.
The fastening kit included in the
package contents is suitable for concrete and wooden floors, as well as the Steinbach
Outdoor Floor Element - . If installing on a stone or granite floor, use assembly
materials that are suitable for these.
8. Clean drilling debris off the setup location.
The setup location is prepared.
Installation
Setting up the solar shower
To install the solar shower, proceed as follows:
1. Position the solar shower at the
prepared setup location.
Make sure that the solar shower is
pointing in the correct direction.
2. Screw in the base of the solar shower.
The solar shower is installed at the setup
location.
2
3
32