Torch Runner (HS)
Torch Runner (HS) Operator’s Manual
21
5.8. Circle cutting attachments
5.8.1. Circle cutting attachment for 240
–1000 mm radius
Allows cutting holes with the radius of 240
–1000 mm (0.8–3.3 ft; when used with the
standard rack). To install, use the 3 mm hex wrench and unscrew two front screws
from the bottom plate, and then use them to tighten the bracket to the exposed holes.
Next, use the 4 mm hex wrench to fix the arm to the side wall with two M5x16
screws. Set the pilot pin above the center of the circle and turn on the magnet with
the magnet lever.
Part number:
CYR-0475-22-00-00-0
Pilot pin
Magnet lever
Bracket
Содержание Torch Runner
Страница 5: ...Torch Runner HS Torch Runner HS Operator s Manual 5 1 4 Dimensions 512 mm 20 2 636 mm 25 199 mm 7 8 ...
Страница 30: ...Torch Runner HS Torch Runner HS Operator s Manual 30 6 115 230 V WIRING DIAGRAM ...
Страница 31: ...Torch Runner HS Torch Runner HS Operator s Manual 31 7 115 230 V HS WIRING DIAGRAM ...
