SM-BM-21S
SM-BM-21
Operator’s Manual
18
When you make bevels of low width, the cutting inserts wear only on one, inner
corner. Then, the good thing is to change the inserts between the milling cutters
(Fig. 7). This will extend the life of the inserts.
Fig. 14.
Changing the cutting inserts between rings
3.6. Replacing the milling head
Remove the milling head cover as shown in Fig. 12. Use the 32 mm flat wrench to
prevent the turn of the spindle (Fig. 15). Then, use the 8 mm hex wrench to remove
the screw, and remove the milling head. The 32 mm flat wrench is not included in
standard equipment.
Fig. 15.
Replacing the milling head
Worn corners
