PB-5 / PBE-5 / PBC-5
PB-5 / PBE-5 / PBC-
5 Operator’s Manual
24
4.9. 75 mm spindle disk
Helps working in places hard to reach.
4.10. 140 mm spindle disk set
Allows
machining
pipes
from inner diameters of 105 mm (4.13
″) to outer diameters of
140 mm (5.51
″).
140 mm spindle disk
1 unit
Jaw blocks (number 7, 8, 9)
3 sets
To install the spindle disk, remove the installed existing spindle disk (Fig. 7, Fig. 8).
Then, use the table that follows to select the correct jaw blocks of the set for the inner
diameter of the pipe to be machined. Use the 3 mm hex wrench to tighten the blocks
to the expanding mandrel (
1
, Fig. 2). Use the 4 mm hex wrench to tighten the tool
bits in the sockets with the screws (
3
, Fig. 2).
Pipe inner diameter
with 140 mm spindle disk set
Jaw block
number
[mm]
[inch]
104.4
–116.6
4.11
–4.59
7
113.6
–125.8
4.47
–4.95
8
122.8
–133
4.83
–5.24
9
Part number:
ZST-0472-15-00-00-0
Part number:
TRC-0472-12-00-00-0
