SM-WC-
LR Li’l Runner (HS)
Li’l Runner (HS) Operator’s Manual
13
3.5. Changing the unit of speed
To change the unit of speed between centimeters per minute and inches per minute,
unplug the carriage from the power source and follow the steps shown in Fig. 4.
Fig. 4.
Changing the unit of speed
After you change the unit and supply the power to the carriage, the current unit of
measure shows. When the jumper cap connects the left and center pin, the display
shows
and the speed is shown in centimeters per minute. When the jumper cap
connects the center and right pin, the display shows
and the speed is shown in
inches per minute.
Put the jumper cap in the position
that matches the required unit.
cm
inch
Use the 2.5 mm hex wrench (not included)
to loosen the screws and get access to the
back side of the control panel.
Содержание Li'l Runner
