D300XT
D300XT Operator’s Manual
20
3.9. Adjusting the gibs
Every 50 work hours, make sure that the gibs are correctly adjusted. To do this,
move the motor up and down and make sure that it moves smoothly.
To adjust the gibs, apply a thin layer of grease on them. Then, use the 8 mm
combination wrench, the 2.5 mm hex wrench, and the 4 mm hex wrench to loosen
the nuts and screws (
1
). Put the motor so that the slider is in the center of the gibs
(
2
). Then, lightly tighten the screws (
3
) so that they touch the gib. Move the motor up
and down and adjust the screws (
3
) so that the travel is smooth. Next, tighten the
screws (
4
) and then tighten the nuts (
5
).
1
2
3
4
5
