SteelMax ARC Runner, Руководство оператора

Страница: 3 / 56

ARC Runner
ARC Runner Operator’s Manual
3
1. GENERAL INFORMATION
1.1. Application
The ARC Runner is a welding carriage designed to make continuous or stitch butt
and fillet welds. The carriage allows MIG/MAG torches with the handle diameter of
16
–22
mm (0.63
–0.87’’).
It is fixed by permanent magnets and can work in the following
welding positions: PA/1F/1G, PB/2F, PC/2G, PD/4F, and PE/4G.
Accessories allow, for instance, welding with oscillation, using torches with the
handle diameter larger than 22 mm, using two torches at the same time, and guiding
the carriage along outside edges, lap joints and templates, walls low or with holes, and
on ceilings, pipes, and tanks.