ARC Runner
ARC Runner Operator’s Manual
16
To
change
the
language
of
the menu,
go
to
setting by
rotating
the
knob F1 to the right and then rotate the knob F2 to choose among the available
languages.
After
the
rest
of the
parameters
from Tab.
1 is set,
go
to
,
choose a program number by rotating the knob F2,
and press the knob to save the
current
values
under
this number. The action is
confirmed
by showing
message
for a short time. To load a previously saved program, proceed as described, but from
setting. Then, to go back to the main menu (Fig. 4), press the
knob
F1
and hold it for 3 seconds. If the chosen parameters are not saved, they will be active
only until the current program number is changed in the main menu.
3.6. Welding procedure
Fig.
6
shows
a
graphic
description of the welding procedure that starts with the speed
value shown in the main menu when selecting a travel direction. The first stage
involves producing the weld, after which the carriage fills the crater (stage 2) for the
chosen time. Next, the carriage performs the backweld (stage 3) and then moves to
the
starting
point
of
the
next
weld
(stage
4).
This
process is repeated until the carriage
reaches the value of the total length.
Fig. 6.
Visualization of the welding procedure according to parameters from Tab. 1
(stage 1)
(stage 3)
Starting point of the first weld
(stage 2)
(stage 4)
Final point of the welding procedure
Содержание ARC Runner
