-20-
ST1008 Mini Wood Lathe
Removing Spur Center
Figure 20. Removing spur center using knock out
bar.
Installing/Removing
Spur Center
The spur center installs into the headstock spindle
with a taper fit.
Installing Spur Center
Figure 19. Inserting spur center into spindle.
3. Check that the center is securely installed by
giving it a quick tug. (A properly installed center
will not pull out by hand.)
1. DISCONNECT LATHE FROM POWER!
2. Insert the tapered end of the center into the
spindle, and push it in quickly and firmly (see
Figure 19).
1. DISCONNECT LATHE FROM POWER!
2. Hold a clean rag under the spindle or wear a
glove to catch the center when you remove it.
3. Insert the knock-out bar through the outboard
end of the spindle and tap the center, as shown
in Figure 20. Catch the center as it falls out.
