Assembly and disassembly
BA_Activa Lift 2 Elektro ©_D_10_2010
15
www.steelcase-village.de
5.3 Setup and alignment
Setup and use of the product requires detailed planning. For this Steelcase Werndl AG offers the
services of its own planning department.
As a rule the partially assembled components of the Activa Lift 2 desk are delivered by the retailer
or directly by the manufacturer.
Checking the
delivery
After unpacking, check the product immediately for damage sustained during transportation and for
completeness; Inform the manufacturer of any damage as soon as possible.
Setup
The setup location must satisfy the following prerequisites for the protection of the desk, drives and
controller:
• The floor must have sufficient load-bearing capacity
• The placement surface must be level
• Temperature range: +5°C - +35°C
• Relative humidity 5% to 80% (non-condensing)
Assembly
Steelcase Werndl AG recommends having the installation executed by authorised personnel
(retailer) or by an installation company.
5.4 Height compensation
To compensate for floor unevenness, you can raise each foot by as much as 1.0 cm with a set
screw.
The following applies for a desk that has already been set up: Before performing the height com-
pensation, remove all heavy objects from the desktop.
Figure 5–1
Height compensation
Turn the set screw until the height is compensated.
1
Set screw
2
Runner
1
2
