Steel City 65-300 X1, Руководство пользователя

Страница: 17 / 27

Page 17
LUBRICATION AND MAINTENANCE
Make certain that both machines are disconnected
from the power source.
GREASE
1. Every 200 hours or 30 days, the rollers should be
greased using a #2 grease or equivalent. Each roller has
grease fitting; refer to indication sticker for grease
locations. Fig. 26
2. Gears and chains: periodically lubricate the gears and
chains with a #2 grease or equivalent.
GEAR OIL CHANGE
After the first 200 working hours, or 30 days, the gearbox
oil should be changed. After the initial oil change, change
every 1000 working hours, or 6 months, with a good
quality gear oil. This recommendation is based on
8 hours/day.
To change oil:
Swing the feeder off the table, open the cover, turn the
feeder upside down, remove the oil cap and completely
drain all oil into a catch pan. After drained, turn the feeder
on vertical feeding position, pour gear oil referring to the
indication on the Lubricant Gauge and reinstall the oil
cap. Fig. 27, 28
Recommended Gear oil: MOBIL Mobilgear 630,
Shell/Omala 150 BP, Energol GR-XP 150, or equivalents.
WARNING
!
Fig. 26
Fig. 27 Fig. 28
CLEANING
Remove working waste (shavings, sawdust) from feeder
by air gun after each use. 50 PSI max.
TROUBLESHOOTING
If an error message occur on the display panel, see
below explanation:
The motor fails to start , please check if anything
stuck in the feeder.
The temperature of driver is too high.
The temperature of the motor is too high.
1. Restart the main power after clearing the possible error.
2. If you cannot identify the cause of the problem, please
seek further technical support.
MAINTENANCE