Steel City 65-300 X1, Руководство пользователя

Страница: 12 / 27

Page 12
3. Insert over-arm (1) into elevating bracket, insert
handwheel (2) and turn it to scroll in the over-arm;
then fasten screw (3) to keep handwheel in position.
Fig. 6
4. Insert the inclined adjustment ring (R) to over-arm,
place over-arm cone onto the end of the over-arm
and tighten one of the screw temporarily. Fig. 7 & 8
5. Clean up the surface with rubbing alcohol before
placing the indicator sticker (S) onto the cone.
Fig. 8 & 9
6. Insert the electric wire into the side hole of the cone.
8.1
7. Install the Easy Flip handle, do not over tighten. The
handle shall remain rotatable. Fig. 10
Fig. 6
Fig. 7 Fig. 8
Fig. 9
Fig. 10
8. Install Control Joint and feeder:
A – Place the 45° Control Joint onto the feeder
cone and tighten the handle. Fig. 11
B - Place the feeder on the machine table, lower the
over-arm so the over-arm cone connects to the
Control Joint, and tighten the lever. Fig. 12
9. Set-up the reference points:
Position the feeder in regular infeed position.
A – 3 rollers feeder: position so tooling is after the
first roller.
B – 4 rollers feeder: position so tooling is between
second and third roller.
Lower feeder rollers onto the machine table to ensure
they are aligned. The Memo-Position pin should be
locked-in. Loosen the screws and adjust the over-arm
cone if the rollers are not parallel to surface.
The inclined adjustment ring should be firmly attached
to the over-arm cone, with the in-line indicator pointing
to 0. Fig. 9
Fig. 11
Fig. 12