Steel City 55230, Руководство пользователя, Страница: 20 / 36

20
ADJUSTMENTS
TILTING SANDER PLATEN
MAKE CERTAIN THE MACHINE IS DISCONNECTED
FROM THE POWER SOURCE.
The platen (E) is the perfectly flat steel plate that has
the graphite covering on it. The platen is the surface the
sanding belt runs against.
WARNING
!
The sander platen can be positioned between 90 Deg.
and 180 Deg.
To adjust platen angle:
1. Loosen platen locking lever (A). SEE FIG. 11.
2. Tilt platen (E) to desired angle.
3. Retighten platen locking lever (A).
Fig. 11
ADJUSTING MAIN TABLE
MAKE CERTAIN THE MACHINE IS DISCONNECTED
FROM THE POWER SOURCE.
WARNING
!
WARNING: Do not position the main table below the
sanding belt. Set at an overlap of at least 1/16". Failure
to comply may cause serious injury!
The main table height and angle can be adjusted.
To adjust main table:
1. Loosen locking handle (B) and lock knob (C).
SEE FIG. 11.
2. Move main table (D) to desired height and/or angle.
3. Retighten locking lever (B) and lock knob (C).
ADJUSTING SANDER PLATEN
POSITIVE STOPS
MAKE CERTAIN THE MACHINE IS DISCONNECTED
FROM THE POWER SOURCE.
WARNING
!
The sander platen has positive stops for both 90 Deg.
and 180 Deg. These positive stops should be set at the
factory. It is still a good idea to familiarize yourself with
the following procedures.
1. The 90 Deg. positive stops (F) can be adjusted by
loosening the lock nut and threading the set screws
in or out.
SEE FIG. 12.
2. Retighten the lock nut after adjustment is made
making sure the set screw does not move.
3. The 180 Deg. positive stops (G) can be adjusted by
loosening the lock nut and threading the bolts in or
out.
SEE FIG. 13.
4. Retighten the lock nut after adjustment is made
making sure the bolt does not move.
Fig. 12
Fig. 13
C
A
D B
E
F
G
VIEW FROM REAR
OF MACHINE
VIEW FROM REAR
OF MACHINE