Steel City 40285, Руководство пользователя, Страница: 22 / 36

19
Figure 53. Finding BDC with the Rotacator.
Figure 54. Table elevation screw housing bracket.
Figure 52. Cutterhead knife at bottom dead center
(BDC).
DISCONNECT THE PLANER FROM POWER!
Raise the headstock cover. (Refer to How to
Check Knives page)
the knife by slowly rocking the cutterhead
pulley back and forth, and set the Rotaca-
tor dial to zero (see
Figure 53) .
the knife just makes contact as it passes
the feeler gauge.
into the leverage hole and turn the bracket
(B) until you are satisfied with the table
parallelism from side-to-side.
elevation housing bracket cap screws ((A)
underneath the table) for that side of the
table (see
Figure 54 ).
Bottom Dead
Center
A
B
Using the cutterhead pulley, rotate the
cutterhead so taht the blade on the left edge
of the cutterhead is at bottom dead center
(BDC) (see
Figure 52 )—this will also place
the knife on the right side of the cutterhead
at BDC.