SteamandGo SAGS3, Инструкция по эксплуатации

Страница: 12 / 15

12
Excrete the remaining water in the machine
In order to avoid that the user not to use the garment steamer for long time, the water
inside will go bad, or provide environment for bacteria to grow. So, there is a drainage cap
on the bottom, you can excrete redundant water after turn off the cap. To avoid the water
come out from the outlet when using next time, please tighten the cap after the water is
out.
Maintenance and descaling operation
Water contains mineral substance, which can result in sediment accumulation in the
appliance and impact the heating efficiency and spurt of steam. The sediments shall be
often cleaned and removed (warm tip: please do the descaling operation once a week if
using frequently). The following ways are suggested for descaling:
1: Firstly, turn off the power switch and pull up the plug so as to make this machine
complete cooling.
2: Make sure the appliance is completely cool. Take the appliance outdoor, as the water
will come out from the appliance. Then open the drainage cap on the bottom of the
appliance (see picture), place a full filled water tank on the appliance, so the water will
flush the boiler and take out the sediment out. If the sediments are not completely cleaned,
repeat above process until the boiler is cleaned.
3: If anything blocks the steamer output, do not use the appliance until the output is
cleaned. The blockage may increase the pressure inside of the appliance. Use small
pincers or other suitable tools to take the blockage out.