5. Attach the connecting rod to the poles as Figure 7
shows. To attach the hanger attachment, align the
hole of hanger with pole top and push down, (Figure
8).
6. Attached the clothes hanger to the pole top hanger,
you should align the clothes hanger hole with pole
hanger tab and push down let it hold in place, like
figure 9 shows.
7. Refer to ironing board installation instruction for how
to install the ironing board.
8. Take out the ironing board, and align the ironing
board to the fixing holes of two side’s poles, screw
the M8 screws by hand. (see figure 10)
9. Fit the two supported poles onto the hook of the
extension poles. (see figure 11)
10. Put the cloth cover on the ironing board, and tighten
it.
Using Your Pressurized Garment Steamer
1. Filling with water, unscrew the safety cap from unit, reference to figure 12 filling
water into boiler.
Caution:
Only filling water, no any other cleaning detergent allowed.
NOTE: To prolong the lifetime of your steamer, we recommend using
distilled or de-mineralized water
.
2. Screw back the safety cap like the figure 13 shows, be sure the cap screw
tighten with boiler, otherwise there is steam leakage from there.
3. Plug the unit into a properly grounded three-pronged outlet. Make sure the
electric voltage is same as the unit spec required.
4. Step the pedal switch on light, the switch is illuminated in RED light, pre-heating
8-10 minutes; the light will turn to Blue once the steam is ready. See figure 14.
.
CAUTION: Close the power switch or pull the plug in time if there is no
steam out. Dry boiler will affect the service life or damage it.
Figure 7
Figure 10
Figure 11
Figure 12
Figure 13
3
Figure 14
Figure 8
Figure 9
