Page 7 of 12
Filling the Tank During Use
Turn off the switch and open the tank and pour in the water. Seal the tank and turn on
to activate the steam.
Warning
: Never place de-scaling, aromatic, alcoholic or detergent products in the
steam mop tank, this will cause damage to the appliance and void your warranty.
Using the Steam Mop
Plug the appliance into the mains power supply and switch on. The indicator lights on
unit will illuminate Green.
It will take approximately 20 seconds for the appliance to preheat, and then the
appliance is ready for use.
Steam will run continuously until turned off or the unit runs out of water.
A full tank will supply approximately 15 minutes of steam. If the water tank is empty,
the pump will make a little pumping noise and will shake; the switch must be turned
off immediately. Refill the water tank following the instructions above.
Using detergent release
1. Fill detergent (diluted with water) by funnel and cup
2. Press the detergent spray button by foot.
Remark: if the spray nozzle becomes clogged, you can clean it by removing it
form the mop head. To remove it, place a flat screwdriver on the nozzle and lift.
The nozzle will pop off. Run the spray nozzle under warm water to clean it out.
Reinsert the spray nozzle into nozzle hole, push it into place.
Using as a Hand-held Steamer
Press the handle tube button to remove the handle from the steam mop body.
Install the accessory adaptor at the top of the steam mop body until it locks into
position.
Choose the required accessories and install by aligning the arrow indicators and
