www.stealthtronic.com | [email protected]
user manual
GLITE PRO 2.0
1
st
Start up
1.
Insert the Nano-SIMcard and wait for about 10 seconds for the device to bootup
2.
Call the unit, and the unit will pick up the call
3
. Wait for unit to send replies, sometimes it can take a short amount of time.
4.
Close the unit with screwdriver, gently tighten
Voice during phone
call (Gain)
Simply, for increasing the signal from the micro-
phone, you use following commands, pressing on
the keypad: #01, #02, to #09 … wait in between the
pressing of DTMF tone.
Activation of VOX
detection
SNDSENS
0 -OFF
1-100 – The lowest sensitivity
The number re
fl
ects the “dB” in the surrounding,
so if you will set it to 30 you will need noise of 30
dB to activate it. Recommend it for activation by
voice is 30-50db
Factory settings
RESET
Factory settings = SLP0, SLPINT15, PWRINT2,
LEDMSK15, MOVESENS0, SNDSENS0
Status of device
STATUS
Password settings
PASSWORD
000 – Turn off
001 - 999 – set number
possibility
If you decide to activate password you will have to
use it for further communication with the device.
For example, if you set PASSWOD777 and you will
want to change the sensitivity you will need to
do so like this 777SNDSENS50
Turn off LED diodes
LEDMSK
0 – OFF
15- ON
You will turn off the led diodes by sending to the
device LEDMSK0
Commands:
- variable
art up
h
d
d
f
b
d f
h d
b
ANTENA
Charging cable
LED diodes can be turned off
4 screws had to be removed
for placing simcard
