6
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
Note:
Ensure the
M.2 Drive
is properly seated, with the pins
making full contact, before proceeding to the next step.
5.
Gently press down on the
M.2 Drive
until the notch on the
M.2 Drive
is aligned with the hole for the
Holding Screw
.
6.
While holding the
M.2 Drive
in place, secure the
M.2 Drive
by replacing the
Holding Screw
that was removed in step 3,
using a
Phillips Head Screwdriver
.
7.
Repeat steps 3-6 to instal the remaining
M.2 Drives
.
8.
Replace the
Drive Bay Cover
that was removed in step 2.
9.
Screw in the two
Drive Bay Screws
that were removed in
step one, using a
Phillips Head Screwdriver
.
(Optional) Connect a Thunderbolt 3 Peripheral
•
Connect a
Thunderbolt 3 Cable
(sold separately) to one
of the
Thunderbolt 3 Ports
on the
Enclosure
and to a
Thunderbolt 3 Port
on the
Thunderbolt 3 Peripheral
.
--Or--
•
Connect a
Thunderbolt 3 Peripheral
directly to one of the
Thunderbolt 3 Ports
on the
Enclosure.
(Optional) Connect Displays
Note:
Connect and setup the
DisplayPort Enabled
Display Device
before connecting and setting up the
Thunderbolt 3 Enabled Display Device
.
