Instruction manual
13
Mount a TV with a flush mounting surface
To accommodate different TV designs, the FPWARTB2 comes with five sets of screws of
different lengths and diameters, two sizes of washers, and two sizes of spacers.
1. To select the combination of mounting hardware that you need to use to attach the
vertical brackets
to the TV, complete the following:
• Determine the depth of the mounting holes on the TV.
• Determine the diameter of the mounting holes on the TV.
Note:
If you’re using a TV with a flush mounting surface, you don’t need to use any of
the provided spacers.
2. Line up the
vertical brackets
with the mounting holes on the back of the TV.
3. Place the
small washers
or
large washers
over the
vertical brackets
.
4. Insert the
M5x14 mm screws
or the
M6x14 mm screws
through the
washers
,
vertical brackets
, and into the back of the TV.
5. Use a Phillips screwdriver to tighten the screws. (
figure 7
)
Warning!
Do not over-tighten the screws. If you encounter resistance while you’re
tightening the screws, stop tightening. Failure to do so could result in damage to the
TV.
figure 7
M5x14 mm screw
M6x14 mm screw
Small washer
Large washer
