LAB01
Manual Label Applicator
Dispenser
Core Holder (2)
Load Label Roll
Reel Guide (2)
ITEMS INCLUDED
1
1
2
Handle
Hex Wrench
Thumbscrew (2)
A: Install handle onto feed roller
B. Install and tighten the thumb screws
A: Place bottle onto rollers and adjust screws
with hex wrench to position rollers until
bottle rests 1 - 2mm above strip plate
B: Tighten screws on both sides and remove
your bottle
3
4
Position Labels
B
A
C
A: Slide reel guide onto the hanger bar
B: Insert core holders into your label roll
and slide loaded roll onto reel hanger bar
C: Slide other reel guide onto the hanger bar
Adjust Height
B
SIDE VIEW
A
A
B
A: Position label roll for desired placement
and tighten thumb screws
B: Feed label liner under guide bar and brush
A
B
bottle
Set Up Dispenser
strip plate
advancement roller
LAB01_Quick_Start_Guide_b072208.Page 1 8/4/2008 2:50:09 PM
