Start italiana MAGLINK 16T, Руководство по установке

Страница: 25 / 48

Maglink 16T rev.08 2015-07 - ENG
25
STRAPPING TABLE
The console has the facility to calculate the volume starting from the height as linear interpolation between two near points. In order to
do that operation the strapping table (correspondence mm – lt) must be downloaded into
the console.
It is necessary to follow few rules in order to download correctly the table into the console:

Values in millimeters/inches and liters/gallons

Maximum number of points: 250

Numbers with decimals have to be written with a dot ( . ) and not with a comma.

Table has to be written in Excel or Note Pad and saved as .csv or .txt.
The .csv format allows to save the data filled into the Excel table separating them with
semicolon symbol ( ; ).
Opening .csv file with Note Pad it will be possible to read data as per the example shown below. Otherwise it is possible to complete
the table manually into program Note Pad separating the values with semicolons.
The strapping table cannot be modified once imported into Console Config.
READ DATA FROM DEVICE read the current table from the console for the selected channel.
WRITE TABLE ON DEVICE download the table referred to the selected channel, which is shown into the above window.
IMPORT TABLE
import .txt or .csv file. After the download the table must be visible into the above window. If nothing
appears it means that an error occurred into the file format.
EXPORT TABLE
import .txt or .csv file.
Perform this operation for each channel.
It is possible to import the same strapping table for the other channels.
Examples of strapping tables:
.csv .txt