STARPLUS STSe Key System, Руководство по установке

Страница: 65 / 94

Keyset/Headset Installation 3-37
Chapter 3 - Installation
STARPLUS STSe - Installation Manual August 2005
Installing a Headset
The STARPLUS STSe digital key telephone is designed to operate with industry-standard 2.5mm
connector headset adapters and operator headsets. Each digital key station can be individually
programmed for Headset operation. When programmed, a headset with its adapter box may
be connected to a key telephone station for Headset use.
To install a headset, either:
Insert the headset’s 2.5mm plug into the 2.5mm connector on the left side of the keyset
-or-
1. Remove the handset cord from the bottom of the Key Telephone unit.
2. Plug the Headset Adapter cord into the vacant handset jack on the Key Telephone base.
3. Then plug the handset and the Headset into the modular jacks of the Adapter box.
This allows handset or headset operation as desired by switching the selector switch on
the Adaptor box. Speakerphone operation is disabled while a station is in Headset Mode.
4. Leaving the handset in place, connect a modular headset to the handset jack located on
the side of the telephone.
REQUIREMENT -- For headset to operate properly, make sure to use a Headset Unit that complies
with the current industry standards.