Stardom SOHORAID ST8-TB3, Руководство пользователя

Страница: 5 / 31

SOHORAID ST8-TB3 User Manual
3
4. Hardware Installation
Please follow the steps below to complete the hardware installation process:
When you open the package, please immediately check the product and included parts for
any damage or missing parts. If there is a problem with the product or included parts please
contact your supplier immediately.
Place the device on a flat, even surface. Make sure that the cooling fan is not blocked
and there is sufficient surrounding space for cooling. (Keep away from water or other
environments that may cause product damage)
Please insert the pin included with the parts pack into the keyhole to release the HDD
enclosure handle and remove the HDD enclosure.
Place the hard disk in the HDD enclosure and secure it in place with the included screws;
this will prevent damage to the hard disk from external vibration.
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
Step 8
Step 9
Once the hard disk is installed, slide the enclosure into the system and close the handle.
Select the appropriate cable from the accessories pack depending on the interface. Connect
the ST8-TB3 backplate connection port to the corresponding port on the computer.
Connect the AC Power cable to the ST8-TB3. Plug the connector into the power socket then
start the system.
Your operating system will automatically detect available capacity once the device finishes
booting. Once the device has been detected, please follow instructions given by the
operating system and format the system. Once the hard disk has been formatted, the ST8-
TB3 can be used.
If the computer is unable to detect the system, please install the drivers from official website
(
www.STARDOM.com.tw
)
Note: Please avoid using hard disk drives from different manufacturers or different
models from the same manufacturer as this may impact system performance.