SafeTANK GT2660-TB3 User Manual
4
6. Remove the release paper from the heat
sink in the upper cover and replace the
upper cover.
7. Lock the screws.
8. When the M.2 installation has been completed, insert the tray into the system horizontally and
secure the latch into place.
9. Please connect the signal cable first, and then power cord later.
10. First turn
the power main switch on the back of the product
to “I” to turn the power on, then
gently press
the touch power on the front of the product
until the power symbol “ ” lights up.
11. After turning on the power, please perform subsequent formatting settings through the operating
system. Please follow the instructions of the computer operating system for M.2 formatting; after
formatting, you can read and write data.
12. If you are not using the product for a while, you can put the product into shutdown mode: first
press
the touch power on the front of the product
until the power symbol “ ” is off; if you want
to use the product, gently press
the touch power on the front of the product
until the power is
turned on. The symbol “ ” is illuminated.
13. If the product is not used for a long time, please turn off the product main power switch: first
gently press
the touch power on the front of the product
until the power symbol “ ” is off, then
turn
the main power switch on the back of the product
to “O” to turn off the power.
14. If the computer is unable to detect the system, please install the drivers from official website (
The product is in a state of near-complete power-off in shutdown mode, and the hard disk,
LCD, and fan are all out of operation, providing only a small portion of power for preparation
for subsequent startup.
★