Starck Sefam S.Box Duo S, Руководство для пациента

Страница: 12 / 40

12  Use S.Box Duo S and S.Box Duo ST
If your device is equipped with a heated humidifier, it starts automatically when the appliance is
switched on. You can increase or decrease the humidification level using the touch key , (see "How
to set the device" page 16).
WARNING:
After a power failure, the appliance will recover the same parameters and operating mode as the ones before the
power failure occured (start / standby).
Stopping of treatment
1. Remove the mask.
2. Press and hold the start / standby button to switch off the device. If it is installed, the heated
humidifier stops simultaneously.
Available features
Mask Fit & Go
You can check the air tightness of your mask before starting the treatment and when the device is in
standby mode. The residual mask leak information can be displayed by tapping the touch button .
Adjust your mask in case of undesired leak. Tap to return to the standby screen.
Mask unplugged
If you remove your mask, the device automatically reduces the flow. The machine will restore normal
flow and pressure when you reconnect you mask or if you press the Start / standby button
or the
ramp button . Otherwise, the machine will stop after 30 minutes. The feature can be used at night
when you need to get up.
Ramp
When enabled, the time ramp feature makes it possible to gradually increase the pressure to help you
fall asleep: the delivered pressure increases from a lower initial pressure called "comfort pressure" up
to the appropriate treatment pressure (during the ramp time.). In BPAP (bilevel) mode, the pressure is
reduced to the comfort pressure and then raised up to the inspiratory and expiratory pressure levels.
If it is active (≠ OFF), the ramp feature starts when the device is switched on. It can be disabled (then
reactivated) by pressing the ramp button
.