S.Box Duo S and S.Box Duo ST
Use
11
Use
Filling the humidifier chamber (if installed)
1.
Unplug the S.Box Duo S or S.Box Duo ST device from the power supply or electrical power grid.
2.
To separate the humidifier chamber from the device, press the button to unlock the humidifier
chamber (mark 4 in Figure 1) and at the same time, pull the humidifier chamber away from the
device using the integrated handle.
3.
Put the humidifier chamber away from the device and pull the opening clip upwards to release the
upper part of the chamber, then put it aside.
4.
Fill the bottom part of the chamber with water up to the maximum level mark indicated by
.
5.
Put the upper part back on the base of the humidifier chamber by positioning the hinge properly,
then press down on the upper part to close the chamber and lock it.
6.
Place the humidifier chamber back on the heater plate, with the hinge side towards the inside of the
machine, and push it against the device until you hear a "click".
7.
Plug the S.Box Duo S or S.Box Duo ST device into the power supply or electrical power grid.
CAUTION:
Be careful not to exceed the maximum level mark.
Fill the chamber only with water at room temperature, do not use hot or chilled water.
It is recommended to use distilled water.
Do not add any product to the water in the chamber (essential oils, etc).
Do not use alkaline solution (physiological saline).
Starting of treatment
1.
Put on your mask as described in the corresponding user instructions. If the Intelligent Start feature
has been activated by your Home Care Provider, the device will start during your first breaths in the
mask.
You can also press and hold the start / standby button
to begin treatment. Recording of
compliance data and of treatment effectiveness
begins immediately in the device memory and on
the SD card when present.
2.
Then, the display of the device indicates the delivered pressure and
if the ramp is enabled (symbol
in the status bar).
The displayed symbols indicate which features and accessories
are activated (see the table "Description of symbols" page 16).
3.
If the message " MASK " appears on the screen, that means your
mask is not properly connected.
Reposition it properly to minimize the leak as much as possible ,
then press the start / standby button
or the ramp button
.
The apparatus will restore the set pressure and the message will
disappear.
4.
Lie down and place the breathing tube so that it can follow your movements while you are sleeping.
Содержание Sefam S.Box Duo S
Страница 1: ...S Box Duo S S Box Duo ST...
Страница 38: ...38 Technical characteristics S Box Duo S and S Box Duo ST...
Страница 39: ......