Attaching the TSP700 vertical stand
1. Unpacking :
Confirm that all accessories are included.
2. Attachment procedures :
Note: Ensure that power that is supplied to the printer
and that all devices connected to the printer have
been switched OFF and that the cables have been
unplugged before starting the modification. If the
AC adapter is connected to the printer, unplug it
from the main socket.
The base for setting the stand should be within a
range of ±2
°
in reference to the horizontal direction.
2-1. Attaching the shafts
Attach the three shafts to the printer.
2-2. Attaching the roll stoppers
Attach the two roll stoppers in the positions shown
in the figure. Ensure that any dirt has been
completely wiped away before attaching the
stoppers.
2-3. Removing the tension bar unit
Use a regular screwdriver to remove the clips at both
ends of the bar to remove the tension bar unit.
fig.2 Attaching the roll stoppers
fig.3 Removing the tension bar unit
fig.1 Attaching the shafts
Shafts(D)
Shaft(C)
M4
×
8 screws (2)
(for attaching the stand)
M3
×
12 screw with flat washer (2)
(for attaching the holder plate)
Roll stoppers
Shafts(D)
Shaft(C)
Brand seal
M3
×
12 screws (2)
(for attaching the holder plate)
Holder plate
Stand
