Star Micronics MG-S Series, Руководство по эксплуатации, Страница: 52 / 114

3 Functions related to the operation MG-S series operation manual
－
42
－
3-11 Adding function
Weigh a plurality of samples to be weighed in sequence and indicates its total value.
The adding function includes two ways of calculating method.
This function is not available for verified balance.
The adding function can be used in Weighing mode, Percentage mode, Counting mode, and
Multiplied by Coefficient mode.
1
Select the adding function. Push [Menu] key, then push [F1-F4] keys to
go to <141 ACTIVATE>
Push [F4] key to change the setting value.
Push [F1/F2] key to select.
OFF : Invalid
ON : Valid
Push [F4] key to fix.
2
Select the adding operation. Push [F1-F4] keys to go to
<142 OPERATION>
Push [F4] key to change the setting value.
Push [F1/F2] key to select.
TOTAL : Addition accumulated
NET : Net addition
Push [F4] key to fix.
3
Select the adding direction.
Push [F1-F4] keys to go to
<143 DIRECTION>
Push [F4] key to change the setting value.
Push [F1/F2] key to select.
PLUS ： Plus side addition
MINUS ： Minus side addition
Push [F4] key to fix.
4
Set the “Free key”.
Set the following function to the <<F1-F6>> (Free
keys).
<62* F* KEY ADD> : Adding execute
<62* F* KEY TOTL> : Total indication
(Refer to “8 Controlling and adjustment functions”
for setting the free keys.)
Step 4 is required only when you are using an adding function on the weighing mode.
- Method of weighing samples to be weighed while replacing the samples: Addition accumulating
function.
- Method of weighing samples to be weighed without replacing the samples: Net adding function.