Stanley STPT600, Руководство пользователя

Страница: 4 / 20

4
ENGLISH
Electrical safety
Labels on tool
Position of Date Barcode
This tool is double insulated; therefore no earth
The following symbols are shown on the tool:
The Date Code (8), which also includes the year of
manufacture, is printed into the housing.
Example:
2014 XX JN
Year of manufacturing
Warning! To reduce the risk of injury, the user
must read the instruction manual.
wire is required. Always check that the power
supply corresponds to the voltage on the rating
plate.
d. Store idle power tools out of the reach of children
and do not allow persons unfamiliar with the
power tool or these instructions to operate the
power tool.
Power tools are dangerous in the hands of
untrained users.
e. Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and any
other condition that may affect the power tool’s
operation. If damaged, have the power tool
repaired before use.
Many accidents are caused by
poorly maintained power tools.
f. Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
g. Use the power tool, accessories and tool bits etc.,
in accordance with these instructions, taking into
account the working conditions and the work to
be performed. Use of the power tool for operations
different from those intended could result in a hazardous
situation.
5. Service
a. Have your power tool serviced by a qualified
repair person using only identical replacement
parts.
This will ensure that the safety of the power tool
is maintained.
Additional Safety Instructions for Blowers
• Do not collect still smoldering cigarette ashes, freshly cut
metals shaving, screws, nails and the like.
•
•
•
•
•
•
•
Never block suction inlet and outlet.
Warning symbols
Do not use in the rain or leave outdoors while it is
raining.
Always wear eye protection.
Always wear ear protection.
Keep bystanders away.
Do not touch the fan.
Do not cross gravel paths or roads whilst your product is
switched on during blow/vac mode. Walk, never run.
Always be sure of your footing, particularly on slopes.
Do not overreach and keep your balance at all times.
Do not place the inlet or outlet of the vacuum near eyes
or ears when operating. Never blow debris in the
direction of bystanders.
Keep all cooling air inlets clear of debris.
To protect your feet and legs while operating the
•
Never allow children to use the appliance.
•
Wear protective goggles while operating.
appliance, always wear heavy duty footwear and long
trousers.
•
•
•
If operating an appliance in a damp location is
unavoidable, use a Residual Current Device (RCD) with a
tripping current of not more than 30mA protected supply.
Use of an RCD reduces the risk of electric shock.
• Store the appliance only in a dry place.
To prevent dust irritation the wearing of a face mask is
recommened.
Disconnect the appliance from the mains supply
- whenever you leave the machine;
- before cleaning a blockage;
- before checking, cleaning or working on the appliance;
- if the appliance starts to vibrate abnormally.
Switch off: remove plug from mains before
cleaning or maintenance.
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Stanley Service
centre in order to avoid a hazard.
The extension cable must be suitable for outdoor use and
marked accordingly. Up to 0.75 mm² H05VV-F or H05RN-F
extension cable can be used without loss of product
performance.