Stanley SCSS-700VS, Руководство по установке и эксплуатации

Страница: 67 / 74

Voice Operation Overview
53796 4-3
4.2 Recording Custom Messages
The VIP-Series controls come with three recorded messages (see Table 4-1). Message 1 & 2
can be changed through the 7780 software; Message 3 can be recorded from the microphone
or by using the 7780 software. Message 1 & 2 are 32 seconds long, and Message 3 is 49
seconds long.
When in the record mode, the following VIP-VCM LEDs will function as follows:
When in the record mode the following VIP-VCM switches will function as follows:
Table 4-1: Preprogrammed Messages
Message No. Voice Gender Message
Message 1 Female
ATTENTION PLEASE. There has been a report of an emergency.
Proceed calmly to the nearest exit and leave the building immediately.
Do not use the elevators. Use stairwells where necessary. All
handicapped occupants shall use the building’s evacuation plan.
Message 2 Male
We have a fire alarm in our building. Please stay in your apartment and
keep your apartment doors closed; Keep your windows shut and leave
all fire doors closed. Do not use the elevators, and stand by for further
instructions.
Message 3 Female
ATTENTION PLEASE. The signal tone you have just heard indicates a
report of an event in the building. Please await further instructions
while the report is being verified. If further action is necessary, you will
be instructed to follow floor response plans.
Table 4-2: LED Functions During Programming
Switch LED Active LED Status Meaning
Switch 1 LED Lit Message stored in user message 3 location.
Switch 2 LED Lit Recording user message.
Switch 3 LED Lit Flash error, need to erase and record again.
Switch 4 LED Lit Erasing user message 3 location in progress.
Note: If a message is already stored in user
message 3 memory location, then the
message played on the aux audio channel
will only play and not record when switch
2 is pressed.
Switch Function
Switch 1 Play back and stop message
Switch 2
Play and stop message on Aux
Audio terminals.
Switch 4 Erase user message 3.
Switch 1
Switch 2
Switch 4