Stanley SCSS-700, Руководство по установке и эксплуатации

Страница: 53 / 258

Control Panel Installation
53722 4-11
4.5 Configuring SBUS Modules
This section describes how to configure any system hardware modules that have been added
to the system.
4.5.1 Assigning SBUS Module IDs
SBUS devices on a panel are addressed from 1 to 63 and are connected to either SBUS 1 or
SBUS 2. Although the addressing scheme allows 63 SBUS devices to be connected to a panel
the actual number is limited by current draw and SBUS bandwidth usage as discussed below.
When installing a hardware module (such as 5815XL, 5824, SCSS-700ANN, 5496, 5895XL,
5865-3 or 5865-4), you must use the DIP switches on the module to assign an ID# to the
module. Address zero is an invalid address and is not allowed.
Figure 4-9 shows all possible DIP switch positions and their correlation to a numerical ID. For
example, to select ID 2, place DIP switch 2 in the up position.
Figure 4-9 Possible SBUS module addresses
Refer to Section 9.2 to edit, add, delete, and view module list
Do Not Use