SAVE THIS INSTRUCTION MANUAL FOR FUTURE REFERENCE.
© 2014 Baccus Global LLC
,
Boca Raton, FL 33432
(877) 571-2391
x
3 WATT HIGH-POWERED LED
HEADLAMP WITH LED AREA LIGHTS
INSTRUCTION MANUAL
HL1S
FEATURES
1. Power/light mode button
2. Headlamp body
3. Adjustable head strap
4. Two white LED area lights
5. Two red LED area lights
6. 3 watt LED bulb
7. Back cover latch release groove
8. Back cover latch
9. Integrated connector tape (connects the
back cover to the battery compartment)
10. Back cover fastening buckles
11. Battery compartment fastening buckle
12. Battery compartment
1
2
3
4
5
6
8
7
9
Back cover
12
10
11
This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not approved by the party responsible for compliance could void
user’s authority to operate the equipment.
SAFETY GUIDELINES / DEFINITIONS
DANGER:
Indicates an imminently hazardous situation which, if not
avoided, will result in death or serious injury.
WARNING:
Indicates a potentially hazardous situation which, if not
avoided, could result in death or serious injury.
CAUTION:
Indicates a potentially hazardous situation which, if not avoided,
may result in minor or moderate injury.
CAUTION:
Used without the safety alert symbol indicates potentially hazardous
situation which, if not avoided, may result in property damage.
RISK OF UNSAFE OPERATION.
When using tools or equipment, basic safety
precautions should always be followed to reduce the risk of personal injury.
Improper operation, maintenance or modification of tools or equipment could
result in serious injury and property damage. There are certain applications for
which tools and equipment are designed. Manufacturer strongly recommends
that this product NOT be modified and/or used for any application other than
for which it was designed. Read and understand all warnings and operating
instructions before using any tool or equipment.
IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS
WARNING: Read all instructions before operating headlamp. Failure
to follow all instructions listed below may result in electric shock, fire
and/or serious injury.
GENERAL SAFETY WARNINGS AND INSTRUCTIONS
WARNING:
This product or its power cord contains lead, a chemical known
to the State of California to cause cancer and birth defect or other reproductive
harm. Wash hands after handling.
WARNING – WHEN USING THIS HEADLAMP, BASIC PRECAUTIONS
SHOULD ALWAYS BE FOLLOWED, INCLUDING THE FOLLOWING, TO
REDUCE THE RISK OF ELECTRIC SHOCK OR INJURY TO PERSONS:
• Use in a dry location only.
• To reduce the risk of injury, close supervision is necessary when the headlamp
is used near children.
• Do not put the headlamp in water or other liquid. Do not place or store
where it can fall or be pulled into water or become wet.
• Use only attachments recommended or sold by the manufacturer.
• Never look directly into the light or shine the light into another person’s eyes.
• Keep sharp objects away from lens — it can crack or break.
• Do not drop or throw this headlamp. It contains alkaline batteries.
• Do not operate the light near flammable liquids or in gaseous or explosive
atmospheres. Internal sparks may ignite fumes causing personal injury.
• When not in use, the appliance should be stored in a dry, well ventilated
place out of the reach of children.
WARNING: FIRE HAZARD:
• Keep headlamp away from materials that may burn.
• Do not expose this unit to extremely high temperatures, sparks or flames.
Inspection and repairs
• Before use, check the unit for damaged or defective parts. Check for
breakage of parts, damage to switches and any other conditions that may
affect its operation.
• Do not use the unit if any part is damaged or defective.
• Have any damaged or defective parts repaired or replaced by the
manufacturer.
• Never attempt to remove or replace any parts other than those specified
in this manual or disassemble the main body of the unit. Other than the 3
“AAA” size dry cell batteries, there are no user-replaceable parts.
• Do not operate this unit with a missing or damaged lens.
ALKALINE BATTERY SAFETY INSTRUCTIONS
WARNING: Batteries can explode, or leak, and can cause injury or
fire. To reduce this risk:
•
Use only “AAA” alkaline dry cell batteries in this unit.
• Carefully follow all instructions and warnings on the battery label and
package.
• Always insert batteries correctly with regard to polarity (+ and –), marked on
the battery and the equipment.
• Do not short battery terminals.
• Do not charge batteries.
• Do not mix old and new or alkaline, standard (carbon-zinc) and rechargeable
(nickel cadmium or nickel metal hydride) batteries. Replace all of them at the
same time with new batteries of the same brand and type.
• Remove dead batteries immediately and dispose of per local codes.
• Do not dispose of batteries in fire.
• Keep batteries out of reach of children.
• Remove batteries if the device will not be used for several months.
“Transporting batteries can possibly cause fires if the battery terminals
inadvertently come in contact with conductive materials such as keys, coins,
hand tools and the like. The US Department of Transportation Hazardous
Material Regulations (HMR) actually prohibit transporting batteries in
commerce or on airplanes (i.e. packed in suitcases and carryon luggage) UNLESS
they are properly protected from short circuits. So when transporting individual
batteries, make sure that the battery terminals are protected and well insulated
from materials that could contact them and cause a short circuit.”
SAVE THESE INSTRUCTIONS
INTRODUCTION
Congratulations on purchasing your new
Stanley 3 Watt High-Powered
LED Headlamp with LED Area Lights
.
Read this Instruction Manual and
follow the instructions carefully before using your new headlamp.
POWER SUPPLY
The unit is powered by three “AAA” alkaline dry cell batteries (may be sold
separately) inside the battery compartment.
Battery replacement/disposal
The battery compartment is located on the back of the head lamp. Refer to the
illustrations at the beginning of these instructions and the steps that follow to
replace the batteries:
1. Use one hand to hold the head lamp body and place the thumb of the
other hand into the back cover latch release groove. Gently lift up the back
cover and push it out by lightly applying force on the back cover latch.
2. Insert the batteries correctly according to the symbols shown inside the
battery compartment, observing the cautions that follow.
3. Replace the back cover by aligning the fastening buckles between the
battery compartment and back cover.
4. Snap the back cover into the head lamp body through the back cover latch.
CAUTIONS:
•
Always read and follow all warnings in the Alkaline Battery Safety
Instructions section of this Instruction Manual before replacing/
disposing of the batteries in this unit.
• The battery compartment inside the headlamp body is connected to the back
cover by integrated connector tape. Do not damage the integrated connector
tape or attempt to disconnect it from either the back cover or the battery
compartment at any time.
• This unit may be delivered with the 3 “AAA” alkaline dry cell batteries
already installed in the battery compartment. If so, they are protected by an
insulation sheet. Make sure this insulation sheet is removed before using the
headlamp for the first time.
• Remove batteries if the headlamp will not be used for a period of time.
OPERATING INSTRUCTIONS
Operating the headlamp
1. Place the headlamp on your head and adjust the strap to fit your head
securely.
2. Turn the headlamp on by pressing the power/light mode button, choosing
the desired light mode as follows:
• Press once for high intensity on the 3W LED light bulb.
• Press again for low intensity on the 3W LED light bulb.
• Press a third time for the two white LED area lights.
• Press a fourth time for the two red LED area lights.
• Press a fifth time for to turn the headlamp off.
• Press and hold the power/light mode button for about two seconds for
flashing (SOS) mode (a continuous sequence of three short flashes/three
longer flashes/three short flashes). Press and hold it again for about two
seconds to return to the previous operating intensity.
IMPORTANT:
When the headlamp dims, the 3 “AAA” alkaline dry cell batteries
need to be replaced.
Pivoting the headlamp main body
The headlamp body is adjustable, allowing the headlamp to be tilted forward
and backward to adjust the area of illumination, as shown below:
CAUTION: TO REDUCE THE RISK OF PROPERTY DAMAGE
• The headlamp was designed to tilt forward and backward only. Do not
attempt to “force” the headlamp beyond its maximum angle.
• The headlamp body is not designed to be detached from the head strap. Do
not attempt to detach it at any time.
• Forcibly and repeatedly tilting the headlamp forward and backward may
damage the pivoting mechanism.
CARE AND MAINTENANCE
If the unit gets dirty, gently clean the outer surfaces of the headlamp with a
soft cloth moistened with a mild solution of water and detergent.
TROUBLESHOOTING
The light will not operate
1. Make sure the Power/Light Mode Button is not pressed to the Off mode.
2. The batteries may be installed with incorrect polarity (+ and –). Follow the
directions marked on the batteries and inside the battery compartment.
3. The batteries may be completely discharged. Replace the batteries
following the directions given in this manual.
4 If the headlamp does not operate after replacing the batteries as directed,
contact manufacturer at 877-571-2391.
ACCESSORIES
Recommended accessories for use with your tool may be available from the
manufacturer. If you need assistance regarding accessories, please contact the
manufacturer at (877) 571-2391.
WARNING:
The use of any accessory not recommended for use with this
appliance could be hazardous.
SERVICE INFORMATION
Whether you need technical advice, repair, or genuine factory replacement
parts, contact the manufacturer at (877) 571-2391.
ONE-YEAR LIMITED WARRANTY
The manufacturer warrants this product against defects in materials and
workmanship for a period of ONE (1) YEAR from the date of retail purchase by
the original end-user purchaser (“Warranty Period”).
If there is a defect and a valid claim is received within the Warranty Period, the
defective product can be replaced or repaired in the following ways: (1) Return
the product to the manufacturer for repair or replacement at manufacturer’s
option. Proof of purchase may be required by manufacturer. (2) Return
the product to the retailer where product was purchased for an exchange
(provided that the store is a participating retailer). Returns to retailer should be
made within the time period of the retailer’s return policy for exchanges only
(usually 30 to 90 days after the sale). Proof of purchase may be required. Please
check with the retailer for their specific return policy regarding returns that are
beyond the time set for exchanges.
This warranty does not apply to accessories, bulbs, fuses and batteries; defects
resulting from normal wear and tear, accidents; damages sustained during
shipping; alterations; unauthorized use or repair; neglect, misuse, abuse; and
failure to follow instructions for care and maintenance for the product.
This warranty gives you, the original retail purchaser, specific legal rights
and you may have other rights which vary from state to state or province to
province. This product is not intended for commercial use.
Please complete the Product Registration Card and return within 30 days
from purchase of the product to: Baccus Global LLC, 595 S. Federal Highway,
Suite 210, Boca Raton, FL 33432.
Baccus Global LLC, toll-free number:
(877) 571-2391.
SPECIFICATIONS
Light:
One 3 watt LED bulb
Two white LED area lights
Two red LED area lights
Power source:
3 “AAA” alkaline batteries (may be sold
separately)
Imported by Baccus Global LLC
595 S. Federal Highway, Suite 210
Boca Raton, FL 33432
(877) 571-2391
RD031314
HL1S_ManualENSP_031314.indd 1
3/13/2014 10:24:53 AM
