background image

x

14 LED PIVOTING WORK LIGHT

INSTRUCTION MANUAL

BF01AL

SAVE THIS INSTRUCTION MANUAL FOR FUTURE REFERENCE.

Copyright © 2017  

Baccus Global LLC, Boca Raton, FL 33432 

(877) 571-2391

SAFETY GUIDELINES / DEFINITIONS

DANGER: 

Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.

WARNING: 

Indicates a potentially hazardous situation which, if not  avoided, could result in death or serious injury.

CAUTION:

 Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury.

CAUTION:

 Used without the safety alert symbol indicates potentially hazardous situation which, if not avoided, may result in 

property damage.

RISK OF UNSAFE OPERATION.

 When using tools or equipment, basic safety precautions should always be followed to reduce the 

risk of personal injury. Improper operation, maintenance or modification of tools or equipment could result in serious injury and 

property damage. There are certain applications for which tools and equipment are designed. Manufacturer strongly recommends 

that this product NOT be modified and/or used for any application other than for which it was designed. Read and understand all 

warnings and operating instructions before using any tool or equipment.

IMPORTANT SAFETY INSTRUCTIONS

READ ALL INSTRUCTIONS

WARNING: Read all instructions before operating light. Failure to follow all instructions listed below may result in 

electric shock, fire and/or serious injury.

GENERAL SAFETY WARNINGS AND INSTRUCTIONS

WARNING: 

This product or its power cord contains lead, a chemical known to the State of California to cause cancer and birth 

defect or other reproductive harm. Wash hands after handling.

WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK:

 

• 

Do not put the light in water or other liquid. Do not place or store the light where it can fall or be pulled into water or become 

wet.

• 

Keep light lamp away from materials that may burn.

• 

Do not clean this appliance with a water spray or the like.

CAUTION: TO REDUCE THE RISK OF INJURY OR PROPERTY DAMAGE:

• 

Avoid dangerous environments:

 – Don’t use the light in damp or wet locations. This unit is NOT waterproof. Do not immerse light in water or other liquids. 

 – Do not operate the light near flammable liquids or in gaseous or explosive atmospheres. Internal sparks may ignite fumes 

causing personal injury.

 – Do not expose this unit to extremely high temperatures, flames or sparks.

• 

To reduce the risk of injury,

 close supervision is necessary when the light is used near children.

• 

Store idle appliances indoors.

 When not in use, appliances should be stored indoors in dry and high or locked-up places – out 

of reach of children.

• 

Use of accessories and attachments. 

Use only attachments recommended or sold by the manufacturer.

• 

Check for damaged parts. 

A part that is damaged should be properly repaired or replaced by manufacturer before further use 

unless otherwise indicated elsewhere in this instruction manual. Have defective switches replaced by manufacturer. Do not use this 

appliance if the light mode button does not turn it on and off.

• 

Do not operate this unit with a missing or damaged light tube.

• 

Do not touch the light tube surface at any time.

• 

Never look directly into the light or shine the light into another person’s eyes.

• 

Do not disassemble the main body of the unit. Other than the 3 “AA” size dry cell batteries, there are no user-replaceable parts.

ALKALINE BATTERY SAFETY INSTRUCTIONS

WARNING – Batteries can explode, or leak, and can cause injury or fire. To reduce this risk:

• 

Carefully follow all instructions and warnings on the battery label and package.

• 

Always insert batteries correctly with regard to polarity (+ and –), marked on the battery and the equipment.

• 

Do not short battery terminals.

• 

Do not charge batteries.

• 

Do not mix old and new, alkaline and rechargeable (nickel cadmium or nickel metal hydride) batteries. Replace all of them at the 

same time with new batteries of the same brand and type.

• 

Remove dead batteries immediately and dispose of per local codes.

• 

Do not dispose of batteries in fire.

• 

Keep batteries out of reach of children.

• 

Remove batteries if the device will not be used for several months.

“Transporting batteries can possibly cause fires if the battery terminals inadvertently come in contact with conductive materials such 

as keys, coins, hand tools and the like. The US Department of Transportation Hazardous Material Regulations (HMR) actually prohibit 

transporting batteries in commerce or on airplanes (i.e. packed in suitcases and carryon luggage) UNLESS they are properly protected 

from short circuits. So when transporting individual batteries, make sure that the battery terminals are protected and well insulated 

from materials that could contact them and cause a short circuit.” 

SAVE THESE INSTRUCTIONS

INTRODUCTION

Congratulations on purchasing your new 

Stanley

®

 Work Light

.

 Read this Instruction Manual and follow the instructions 

carefully before using your new work light. 

FEATURES

6

7

8

1

3

2

4

 1.  Magnetic base

 2.  Base cover

 3.  Base screw

 4.  Three (3) “AA” alkaline dry cell batteries (may be sold separately) 

 5.  Hanging hook

 6.  14 ultra bright LEDs

 7.  Pivot tube

 8.  Light mode pushbutton (High/Medium/Off/Flash)

5

POWER SUPPLY

The unit is powered by three “AA” alkaline dry cell batteries (may be sold separately). Unscrew the base cover screw (counter-

clockwise) and remove the base cover. Insert batteries as described in compartment, observing the cautions that follow. Replace and 

secure the base cover by screwing the base cover screw clockwise. Do not be over-tighten.

Note: 

Use only “AA” alkaline dry cell batteries in this unit.

CAUTIONS

• 

When replacing the “AA” alkaline dry cell batteries: Do not mix old and new, alkaline and rechargeable (nickel cadmium or 

nickel metal hydride) batteries. Always insert batteries correctly with regard to polarity (+ and –), marked on the battery and the 

equipment. Remove dead batteries immediately and dispose of per local codes.

• 

Follow all warnings regarding batteries in the Important Safety Instructions section of this manual.

OPERATING THE LIGHT

• 

Position the unit as desired. Press the light mode pushbutton on the front of the unit.

• 

Press once for high intensity.

• 

Press again for medium intensity.

• 

Press a third time for to turn the light off.

• 

Press and hold the light mode pushbutton for about five seconds for flashing LEDs.

Adjusting the pivot tube

The pivot tube allows the light to be tilted backward and forward to direct the illumination upward or downward. 

CAUTION: TO REDUCE THE RISK OF PRODUCT DAMAGE:

• 

Do not attempt to “force” the pivot tube beyond its maximum angle.

• 

The pivot tube was designed to tilt forward and backward only.

• 

The pivot tube was designed to be used when the unit is hanging or attached to a surface using its magnetic base. Using it when 

the unit is placed on a level, non-metallic surface may cause the light to fall over and sustain damage.

• 

NEVER attempt to rotate the light tube itself. Always use the pivot tube to adjust the area of illumination. 

Using the hanging hook and magnetic base

The hanging hook and magnetic base allow you to position the light for convenient, hands-free operation. The hanging hook 

rotates 360° to direct illumination as needed.

CAUTION: TO REDUCE THE RISK OF PRODUCT DAMAGE:

• 

When light is hung by the hanging hook or attached using the magnetic base, do not shake the light or object that it is hanging 

from or attached to. Do not hang the light from or attach the light to any electrical wires or anything that it is not secure.

• 

Only use the hanging hook for hanging the light. The hanging hook is not intended to support additional weight. Do not attach or 

hang anything additional to the light or risk of breakage may occur.

CARE AND MAINTENANCE

Never submerge the unit in liquids of any kind. If the unit gets dirty, gently clean the outer surfaces of the closed body casing with a 

soft cloth moistened with a mild solution of water and detergent.
Except for the batteries, there are no user-serviceable parts inside. Contact the manufacturer if any components have become worn 

or broken.

Safe Battery Disposal

Refer to the Safety Warnings in the front of this Instruction Manual when selecting and replacing batteries. Always dispose of used 

batteries properly.

WARNING: TO REDUCE THE RISK OF INJURY/EXPLOSION:

• 

Do not dispose of batteries in fire as this may result in an explosion.

• 

Do not expose the unit containing batteries to fire or intense heat as it may explode. 

TROUBLESHOOTING

Light will not operate

 1.  The base cover screw may be loose. Screw the base cover screw clockwise to secure. Do not over-tighten.

 2.  The batteries may be completely discharged. Replace the batteries following the directions given in this manual.

 3.   If the light does not operate after replacing the batteries, contact manufacturer at (877) 571-2391.

ACCESSORIES

Recommended accessories for use with your tool are available from the manufacturer. If you need assistance regarding accessories, 

please contact the manufacturer at (877) 571-2391.

WARNING:

 The use of any accessory not recommended for use with this appliance could be hazardous.

SERVICE INFORMATION

Whether you need technical advice, repair, or genuine factory replacement parts, contact the manufacturer at (877) 571-2391.

ONE-YEAR LIMITED WARRANTY

The manufacturer warrants this product against defects in materials and workmanship for a period of ONE (1) YEAR from the date 

of retail purchase by the original end-user purchaser (“Warranty Period”).
If there is a defect and a valid claim is received within the Warranty Period, the defective product can be replaced or repaired in the 

following ways: (1) Return the product to the manufacturer for repair or replacement at manufacturer’s option. Proof of purchase 

may be required by manufacturer. (2) Return the product to the retailer where product was purchased for an exchange (provided 

that the store is a participating retailer). Returns to retailer should be made within the time period of the retailer’s return policy 

for exchanges only (usually 30 to 90 days after the sale). Proof of purchase may be required. Please check with the retailer for their 

specific return policy regarding returns that are beyond the time set for exchanges. 
This warranty does not apply to accessories, bulbs fuses and batteries, defects resulting from normal wear and tear, accidents, 

damages sustained during shipping, alterations, unauthorized use or repair, neglect, misuse, abuse, and failure to follow instructions 

for care and maintenance for the product.
This warranty gives you, the original retail purchaser, specific legal rights and you may have other rights which vary from state to 

state or province to province. This product is not intended for commercial use. 
Please complete the Product Registration Card and return within 30 days from purchase of the product to: Baccus Global LLC, One 

City Centre, 1 North Federal Highway, Suite 200, Boca Raton, FL 33432. 

Baccus Global LLC, toll-free number: 1-877-571-2391. 

SPECIFICATIONS

Light Bar: 

14 bright white LEDs

Power source: 

3 “AA” alkaline batteries (may be sold separately)

Imported by Baccus Global LLC, One City Centre, 1 North Federal Highway, Suite 200, Boca Raton, FL 33432 

www.Baccusglobal.com • 1-877-571-2391

RD101117

BF01AL_ManualENSP_101117.indd   2

10/11/2017   12:09:10 PM

Отзывы: