Page 21
8.9 SCANNING
The
HX40
provides two types of scanning, “Memory Scan” or “Priority Scan”.
“Memory Scan” scans the channels that were programmed into Scan Mem-
ory and also channels stored in the Preset Channel memory. “Priority Scan”
is similar to the “Memory Scan” scan, however it scans the priority channel
(channel 16) and dual watches to channels programmed in memory scan
and preset channel memory. When an incoming signal is detected on one of
the channels during scan, the radio will pause on that channel, allowing you
to listen to the incoming transmission.
8.9.1 PROGRAMMING SCAN MEMORY
1. Press and hold the [
ENT/MENU
] key.
2. Press the [▲] or [▼] key to select “
CHANNEL SETUP
”.
3. Press the [◄] or [►] key to select the [
SELECT
] soft key, then press the
[
ENT/MENU
] key.
4. Press the [▲] or [▼] key to select “
SCAN MEMORY
”.
5. Press the [
ENT/MENU
] key.
6. Press the [▲] or [▼] key to select a desired
channel to be scanned.
7. Press the [◄] or [►] key to select the [
MEM
]
soft key, then press the [
ENT/MENU
] key.
The “ON” icon will appear at the right side of
the selected channel.
8. Repeat step 7 for all the desired channels to be scanned.
9. To REMOVE a channel from the list, select the channel. Press the [◄]
or [►] key to select the [
MEM
] soft key, then press the [
ENT/MENU
] key.
The “ON” icon of the selected channel will disappear.
10. When the selections are complete, press the [
CLR
/
] key to return to
radio operation.
To check channels to be scanned, press the [▲] or [▼] key repeatedly, to
display each channel. The “
MEM
” icon will appear when a designated mem-
ory channel is displayed.
8.9.2 SELECTING SCAN TYPE
1. Press and hold the [
ENT/MENU
] key.
2. Press the [▲] or [▼] key to select “
CHANNEL SETUP
”.
3. Press the [◄] or [►] key to select the [
SELECT
] soft key, then press the
[
ENT/MENU
] key.
4.
Press the [▲] or [▼] key to select “
SCAN TYPE
”.
5. Press the [
ENT/MENU
] key.
