Standard Horizon GX2400GPS, Руководство пользователя

Страница: 68 / 148

66
3. Press the [◄] or [►] key to select the first number of
latitude, then press the [ SELECT ] soft key to step to
the next number.
4. Repeat step 3 to set the position and time.
If a mistake is made, press the [◄] or [►] key to select
“←” or “→”, press the [ SELECT ] soft key until the incor -
rect character is selected, then perform step 3.
5. When finished programming the position and time, press the [ FINISH ] soft
key. The display will return to the previous screen.
6. Press the [ OK ] soft key.
7. Press the [ CLEAR ] key to return to radio operation.
11.6.5 Setting up a Position Request Ringer
The transceiver has the capability to turn off the position request ringer.
1.
Press & hold [
]

“ DSC SETUP ”

“ DSC BEEP ”
2. Rotate the DIAL/ENT knob to select “ POS REQUEST ”,
then press the [
SELECT
] soft key.
3. Rotate the DIAL/ENT knob to select “ OFF ”.
4. Press the [ ENTER ] soft key to store the selected
setting.
5. Press the [ CLEAR ] key to return to radio operation.
To enable the ringer tone, repeat the above procedure, rotate the DIAL/ENT
knob to select “ ON ” in step 3 above.
11.7 POSITION REPORT
The feature is similar to position request, however instead of requesting a position
of another vessel this function allows you to send your position to another vessel.
11.7.1 Transmitting a DSC Position Report Call
DSC Position Report Call using the Individual/Position Directory
Refer to section “ 11.4 INDIVIDUAL CALL ” to enter information into the indi -
vidual directory.
1.
[ ]

“ DSC CALL ”

“ POS REPORT ”