Standard Horizon ECLIPSE, Руководство пользователя

Страница: 72 / 98

70
11.3.1 ATIS Code Setup (GX1400GPS/E only)
1. [
]

“ SETUP ”

“ ATIS SETUP ”

“ ATIS CODE ”
2. Press the [◄] or [►] key to select the first number
of your ATIS, then press the [
SELECT
] soft key to
step to the next number.
ATIS CODE INPUT
1st:
- ---------
BACK FINISH SELECT
3. Repeat step 2 to set your ATIS (ten digits).
4. If a mistake was made entering in the ATIS, press
the [▲]/[▼]/[◄]/[►] key to select “←” or “→”, press
the [ SELECT ] soft key until the wrong number is
selected, then perform step 2.
5. When finished programming the number, press the
[ FINISH ] soft key. The Radio will ask you to input
the ATIS number again. Perform steps 2 through
4 above.
ATIS CODE INPUT
1st:
**********
- - - - - - - - - -
2nd:
BACK SELECT FINISH
6. After the second number has been input, press
the [ FINISH ] soft key to store the ATIS number in
memory.
7. Press the [ OK ] soft key to ret urn to radio operation.
ATIS CODE INPUT
STORED CODE
9366901230
OK
11.3.2 ATIS CH Group
The GX1400GPS/E has the capability to turn on and off the ATIS feature for
each channel group.
1. [
]

“ SETUP ”

“ ATIS SETUP ”

“ ATIS GROUP ”
2. Press the [▲] or [▼] key to select the channel group
(International, Canadian*, or USA) you wish to
change the setting, and press the [ SELECT ] soft key.
(*: Depending on the region setting.)
BACK SELECT
ATIS GROUP
USA
INTL
CAN
OFF
OFF
OFF
3. Press the [▲] or [▼] key to select “ ON ” or “ OFF ”.
BACK ENTER
USA
OFF
ON
4. Press the [ ENTER ] soft key to save the store setting.