Standard Change-Makers CMP-20, Руководство по эксплуатации

Страница: 31 / 56

Page 31 of 56
An amount owed from a Change (type) dispenser cannot be transferred to a Token dispenser. It can
only be transferred to another Change hopper.
Note: The Transfer Always mode differs from the others in that it has the ability to disable
individual bill acceptance. It will transfer unpaid balances to higher valued dispensers if necessary
and will disable acceptance of bills that it can no longer make change for. All other transfer modes
will shut the entire machine down if it cannot make change for all bills it is capable of accepting.
x
Maximum Dispense Rule – this rule is used in conjunction with the transfer always feature to
disable accepting certain bill denominations in order to avoid giving out large quantities of small
denomination coins or bills. In other words, even if a lower valued dispenser exists, the owner does
not wish to accept the bill and end up giving the user to many coins or bills. An example of this
would be if the owner does not want to give a user $20 worth of dimes in the event that the dime
dispenser is the only one still in service. In this case the max dispense rule for the dime
dispenser
would be set to a small number. Additional machine signage or the optional “dispenser not available
when lit” kit is recommended in order to let the user know why their bill deposit is being rejected.
x
Expanded Programming – this feature is intended for advance users only and for very unique
machine operating requirements. We strongly recommend that this feature not be activated.
x
Make Best Change – used to reduce amount of programming. This feature is the machine’s default
capability to complete a transaction by making the “best change” for the bill or coin accepted with
the available dispensers that are functioning properly. For example: if you are issuing quarters then
the machine can easily figure out how many to give out for each bill; no need to program the
dispense for every bill. We strongly recommend this setting remain YES to avoid programming
errors that could result in mis-pays.
x
Use the “value” “type” dispenser? – An example would be “Use the 25¢ coin dispenser?” You
can choose which value and type of dispenser to use to Make Best Change. The “value” and “type”
will be filled in for each dispenser that you have.
x
Display Dispense Items Used ? – If YES then the items that were dispensed will be shown on the
user display after the dispense has finished.
x
Update the Time –
1. set the current date
2. set the day of the week
3. set the time along with AM or PM
4. Select the time zone. This will be set to Eastern Time Zone at the factory.
5. Select if you are using Daylight Savings by entering YES or NO. This is the only setting you
will have to update when Daylight Savings changes. In the spring set it to YES and in the fall
set it to NO.
6. If you have an internet connection and you want the EF+ Module to check its time enable the
internet time check.
x
Update Sleep Settings – This setting allows you to automatically place the machine in a sleep
mode (inhibit) during periods of the day when you do not want it to be used or when it is not
supposed to be used. One start time and sleep duration time setting is available for each day of the
week.
x
Update PIN Settings – used to control access to certain feature groups based on a PIN
identification number. This feature is used primarily when non-machine owners will have access
to the machine. You will be required to enter a Master PIN, which allows you complete access.
Next you could enter up to six secondary PINs. With each secondary PIN you can allow read and
write, only read or no access at all to each Main Menu feature. Once a PIN has been entered the
user will be required to enter a PIN for any access to the menu. A PIN of 0000 (the default) removes
that PIN. There must be a Master PIN to have a secondary PIN.