V2.2
2022 RUNGU Dualie Rugged/XR series
Copyright 2021 Standard Bearer Machines, LLC
71
Toggling the Rungu E-Light on and off
If you have the Rungu E-Light with your DUALIE, the Rungu E-Light toggle turns the light on and off.
Press and hold the Rungu E-Light toggle for two seconds and release to turn the light on. Do the same to
turn it off. The screen will dim when you turn the light on for nighttime visibility.
Choose the AL Sensitivity setting in Display Settings, to have the light turn on automatically in low light
environment. The option has five levels of sensitivity so that the light sensor in the display will decide
when to turn on the light based on surrounding light levels.
Turning off Dualie
Use the on/off key to turn off Dualie. Dualie also turns off if left idle for a few minutes. Display settings
control the amount of time in minutes.
Built-in USB charging port
The Display has a USB (Type A) charging port under the bottom of the display protected by a rubber
cover. Lift the cover to access the port.
You can charge your phone or power a GPS unit with a standard USB charging cable.
PIN Code
You can also prevent accidental or unwanted Dualie activation by implementing a PIN code at power-on.
Using the Display setting
“Password,” set a
four-digit password for powering Dualie. The next time you
power Dualie, the Display will require you to enter the
four digits using the “+” and “
-
“ keys
to scroll 0
through 9 and advance to the next digit
using the “i” key. The Display Setting item is described in the
“
Rungu MDV Display User Guide
” that you can find online at
Walk assistance
Dualie can also help you push if you are walking alongside. Hold the
“
-
“ key down for more than two
seconds; the motor turns and will help you push Dualie at approximately 3 miles per hour
–
walking
pace.
