ASSEMBLY INSTRUCTIONS
8
Allen Wrench
Thread the
RIGHT PEDAL(27)
into the
RIGHT CRANK(58)
located inside the
CRANK COVER(22)
as
shown. Tighten the pedal securely. Select the
RIGHT PEDAL STRAP(28)
which has
R
marked on the
bottom side of the strap. Snap the three hole end onto the inside edge of the
RIGHT PEDAL(27).
Snap the
other end onto the outside edge of the
RIGHT PEDAL(27)
with the
R
mark on the bottom of the
RIGHT
PEDAL STRAP(28).
Select adjustment holes which allow your foot to be easily removed from the pedals.
Use the same procedure to attach the
LEFT PEDAL(25)
into the
LEFT CRANK(57)
and snap the
LEFT
PEDAL STRAP(26)
onto the
LEFT PEDAL(25).
The
RIGHT PEDAL(27)
has
R
stamped on the end of the pedal shaft. The
RIGHT PEDAL(27)
has
right hand threads and is tightened by turning clockwise. The
LEFT PEDAL(25)
has
L
stamped on
the end of the pedal shaft. The
LEFT PEDAL(25)
has left hand threads and is tightened by turning
counterclockwise.
STEP 6:
Insert the
SEAT POST(3)
into the
REAR FRAME(2).
Then Insert the
SOCKET HEAD BOLT
(M6x1x15mm)(114)
through the upright tube of
REAR FRAME(2)
and bolt onto the
SEAT POST(3).
Screw
the
SPRING KNOB(64)
into the
REAR FRAME(2)
to secure the
SEAT POST(3)
in position
.
NOTE:
STEP 5:
Refer to the inset drawing. Insert the
ADJUSTMENT BLOCK(38)
into the
SEAT POST(3).
Insert
the
SEAT ADJUSTMENT LEVER(63)
through the
SEAT POST(3)
and
ADJUSTMENT BLOCK(38)
and
secure by tightening the
SET SCREWS(M6x1x15mm)(98)
inside the
ADJUSTMENT BLOCK(38)
with
Allen Wrench.
The pin on the
SPRING KNOB(64)
must be inserted into one of the adjustment holes in the
SEAT
POST(3).
The
SPRING KNOB(64)
should be screwed in tight to make the
SEAT POST(3)
fit
securely in the
REAR FRAME(2).
STEP 4
NOTE:
(98) Set Screws
Содержание 15-9100C
Страница 18: ...18 PRODUCT PARTS DRAWING FRONT BACK...
Страница 21: ...NOTES 21...
