Stahl IBPC-5x1, Руководство по эксплуатации

Страница: 18 / 24

Operating Instructions Industrial Box PC System modifications
Page 18 of 24

R. STAHL HMI Systems GmbH / OI_Industrial_Box_PC_en_V_01_00_00.docx / 26.09.2018
10.4 Retrieving the BIOS set-up

To retrieve the BIOS set-up, press the F2 key (repeatedly, if necessary) when the Box
PC starts up.

The BIOS set-up starts up. You can access further setting options in the BIOS set-up if
you select one of the registers.
11 System modifications
Any changes to or repairs of the device may only be carried out by
trained, qualified staff. Repairs made by unqualified staff will render
the guarantee null and void, and may result in substantial risk for the
user (electric shock, fire)!
Before opening the Box PC, please take note of the following:
- The Box PC must be switched off and must not be in energy
saving mode.
- Pull the plug.
- Make sure you do not trap any cables when installing or
removing any components.
11.1 Notes on assemblies

Be careful with the locking mechanisms (detents and centring bolts) when you replace
assemblies or assembly components.

Please note that certain components on the mainboard may be very hot shortly after the
Box PC has been active.

To prevent damage to the assembly and its components and circuit paths, install and
uninstall them very carefully.

Do not use sharp objects (screw drivers) as levers.

Assemblies with electrostatic sensitive components (ESD) may be marked with the label
shown below.

When handling ESD assemblies you must take note of the following:
- you have to equalize your static potential (e.g. by touching a grounded object)
before working with these assemblies.
- Any tools or devices used must be free of static charge.
- Touch the assemblies only at their edges or, if these exist, at points marked in green
(touch points).
- Do not touch any connection pins or circuit paths on the assembly.
NOTICE
CAUTION